Features:
- UTON Diy mini deck light kit
- Small in size
- Long Lasting Built in LED Chip
- Low Running Costs
- D.I.Y. Plugs for easy installation
Kit Includes:
- 6 x light fittings
- 1 x ip66 led driver
- 4 metre extension
- RGB Remote Controller
Specifications:
- Input Voltage: 12v DC
- Power (w): 6 x 0.5w ( total 3w)
- Material: Polycorbonate
- Colour: White
- IP Rating (IP): IP67
- Cut Out: 35mm
- Diameter: ø30mm
- Height: 28mm
- Lumens: RGB (N/A)
- Lamp Base: Built In LED
- Warranty: 2 years replacement
Order Code:
Choosing a driver
This deck light runs on 12v DC, so it needs a 12v LED driver (sometimes called a transformer). It cannot connect straight to 240v mains. The driver is wired in by a licensed electrician.
Allow 3w for each deck light and add about 20% headroom. 10 deck lights draw 30w, so they need a 12v driver of at least 36w, which in practice means a 60w driver.
| 12v driver size |
Maximum deck lights |
| 30w |
8 |
| 60w |
16 |
| 100w |
27 |
| 150w |
41 |
For bigger installs, split the lights across two or more drivers and place each driver close to its group. Long cable runs at low voltage lose brightness at the far end, so check your cable size with the voltage drop calculator below.
Outdoors, use a weatherproof IP66 12v driver and mount it above ground, clear of garden beds and pooling water.
Planning your install? Use our voltage drop calculator to choose the right cable size for your run and keep every light at full brightness.
